GPF OFF service in Tbilisi
GPF OFF Gasoline particulate filter software deactivation
GPF (Gasoline Particulate Filter), also known as OPF (Otto Particulate Filter), is a particulate filter for gasoline engines. When a fault appears, the filter becomes loaded, or the exhaust system is modified, we check the filter and relevant data and prepare software changes for the specific ECU.
Filtration
- Pressure difference
- 12mbar
- Temperature
- 410°C
Gas passes through porous walls, while solid particles remain in the GPF channels.
System operation
What is GPF and how does it work?
GPF, also called OPF, traps solid particles in gasoline-engine exhaust. Its alternately plugged channels direct gas through porous walls, while particles remain inside.
At a suitable temperature, accumulated soot burns off — this is called regeneration. It often occurs during normal driving. Some systems actively raise exhaust temperature when needed.
GPF can be a separate unit or integrated with the catalytic converter. Control and monitoring differ by engine and ECU, so we adapt the software to the existing exhaust system.
Software changes
- The relevant GPF / OPF software control logic is disabled
- Active filter regeneration requests are disabled where the software uses them
- The relevant filter loading and efficiency monitoring is modified
- GPF-related fault codes and corresponding software restrictions are disabled
- Other GPF-related software parameters are modified according to the vehicle and ECU
This work concerns GPF control. We check catalytic-converter and lambda-sensor functions separately; their deactivation is not automatically included.
Identifying the problem
When do we check the GPF filter?
Filter warning
A filter warning or a related fault code appears on the dashboard. We check loading, temperature and the data available from the ECU.
Restricted exhaust flow
When power is lost, we check the filter condition and exhaust flow. Other faults can cause similar symptoms.
Modified exhaust system
After GPF removal or exhaust modification, the software must match the actual configuration. We first check the sensors and installed components.
Software deactivation cannot replace physical filter removal. We clarify the required mechanical work in advance, especially when GPF and the catalytic converter share one housing.
Steps
Four stages of the work
- Diagnostics and readingWe check GPF faults, data and exhaust configuration. We read the ECU software using OBD, Bench or Boot.
- Individual calibrationWe adapt the software to the existing system and modify the relevant GPF control, regeneration and monitoring.
- Writing the softwareWe write the modified file to the ECU and verify that writing has completed.
- TestingWe check engine operation, relevant faults and the available exhaust-system data.
Questions and answers
Frequently asked questions
Are GPF and DPF the same?
Both filter solid particles, but GPF / OPF is for gasoline engines and DPF is for diesel engines. Their operating conditions, regeneration and software control differ.
Does the filter also need to be removed?
Yes. Software deactivation must be coordinated with physical filter removal. If GPF and the catalytic converter share a housing, we first clarify the unit construction and required mechanical work.
Does GPF OFF also increase power?
If GPF was causing power loss, resolving the filter problem and corresponding software restriction may restore the lost power. For an additional power increase, we prepare Stage 1 or Stage 2 software separately.
Does it guarantee passing vehicle inspection?
No. Removing the filter increases particulate emissions. The inspection result depends on vehicle condition and compliance with current requirements; we cannot promise a pass in advance.
A GPF problem or a modified exhaust system?
Send us the model, year, engine and fault code. Tell us whether the filter is installed or removed and what was changed in the exhaust. Consultation is free.