Torque Monitoring in Tbilisi
Torque Monitoring OFF Software deactivation of torque monitoring
Torque Monitoring is a software function that checks engine torque. If power is restricted under load or limp mode occurs after tuning, we check fault codes, torque data and the existing software, and explain whether repair, calibration adjustment or software deactivation of selected monitoring is needed.
Existing potential
- Torque
- 500Nm
- Power
- 294.9HP
- Engine speed
- 4200RPM
Requested torque and the ECU estimate for an already modified calibration. Readings are illustrative.
How the system works
What is torque monitoring?
Torque (Nm) and engine speed (RPM) are different readings. The ECU determines required torque from the accelerator pedal and other systems’ requests, and calculates produced torque using sensors and a software model, without measuring it directly at the shaft.
Monitoring checks whether calculations and requests agree. If they differ significantly, the ECU may restrict power or activate limp mode. Restrictions related to engine condition, temperature and transmission operate separately.
Torque Monitoring OFF is software deactivation of selected monitoring on compatible gasoline and diesel ECUs. We first check how it relates to engine and transmission control.
Software changes
- Adjust the torque-calculation model
- Tailor calibration to the engine and installed components
- Deactivate selected monitoring in software on a compatible ECU
- Coordinate engine-control settings with transmission requests
- Change other torque-related software parameters for the vehicle and ECU
In some cases, correcting the existing calibration is sufficient.
Identifying the problem
When do we check monitoring?
Power and limp mode
Power is restricted under load or limp mode is activated. We check fault codes, sensors and the reason for the restriction, with both factory and modified software.
Modified software or components
If a restriction appears after tuning or changes to the turbocharger or fuel system, we check whether the calibration and torque model match the installed components.
Transmission request
Torque reduction during a gear change may be a normal transmission request. We use data to determine whether this is normal operation or a software or technical fault.
Software cannot replace repairs. Mechanical engine faults, turbocharger, fuel-system, sensor or wiring faults, transmission wear and overheating require appropriate diagnosis and repairs. Software changes do not increase component durability.
Steps
Four steps of the work
- Diagnostics and readingWe check fault codes and requested and calculated torque. We read the ECU file using OBD, Bench or Boot. For previously modified software, we also establish whether the original file is available.
- Individual calibrationWe check engine and transmission requests. Depending on the agreed work, we correct the calibration or disable selected monitoring.
- Writing the softwareWe write the processed file to the ECU and verify that writing is complete.
- TestingWe compare requested and calculated torque, and check fault codes and the conditions in which the restriction occurred.
Questions and answers
Frequently asked questions
Is this part of tuning or a separate service?
We also check torque management during Stage 1 / Stage 2 calibration. Separate work is needed when a restriction or monitoring fault occurs with the existing software. Not every tune requires monitoring to be disabled.
Will this change alone increase power?
If monitoring intervention restricts the power already provided for by modified software, disabling it may remove that restriction. Additional power and torque depend on engine capabilities and suitable calibration.
Are all restrictions and protection functions disabled?
No. We disable only the agreed monitoring. We first check its relationship with other engine and transmission functions.
Does the transmission software change automatically too?
No. Processing the ECU file does not automatically change transmission-control software. We check transmission requests and compatibility with the engine software. If the transmission needs separate software work or repairs, we agree this in advance.
Is power restricted under load?
Send us the model, year, engine and transmission. Include fault codes and describe when the restriction appears and whether the software has been modified — we will explain which data are needed. Consultation is free.